Automated Red/Green Science

Post pictures and videos of your factories.
If possible, please post also the blueprints/maps of your creations!
For art/design etc. you can go to Fan Art.

Post Reply
Zimme2579
Burner Inserter
Burner Inserter
Posts: 12
Joined: Wed Apr 15, 2015 2:05 am
Contact:

Automated Red/Green Science

Post by Zimme2579 »

Hi this is the first automated science factory i have made myself and I was wanting some feedback, I am open for criticism so please criticize. Image

ratchetfreak
Filter Inserter
Filter Inserter
Posts: 952
Joined: Sat May 23, 2015 12:10 pm
Contact:

Re: Automated Red/Green Science

Post by ratchetfreak »

press alt so the recipes are show on the assemblers

It helps immensely when sharing designs
hint

SirRichie
Fast Inserter
Fast Inserter
Posts: 244
Joined: Wed Feb 25, 2015 4:50 pm
Contact:

Re: Automated Red/Green Science

Post by SirRichie »

Just a curious question: is this a design from the editor? Usually, one does not have access to express belts before some serious science automation

User avatar
DerivePi
Filter Inserter
Filter Inserter
Posts: 505
Joined: Thu May 29, 2014 4:51 pm
Contact:

Re: Automated Red/Green Science

Post by DerivePi »

For the layout, we have:
----------- Gears----- Trn Belt-- Green Science
FE Plate-- Cu Cable-- Inserters- Science Research
CU Plate-- Circuits-- Red Science

General Comments -
Design is limited with inputs of only 1 line of FE Plates and 1 line of CU Plates - No need for 4 inserter/transport belt assemblers
For circuit design, it is a fairly accepted rule that CU Cable be directly inserted into the circuit assemblers at a 3 Cu Cable to 2 Circuit ratio
In order to allow for the expansion of science to Red, Green and then Blue and purple, the Red and Green Science flasks should share the same belt (red on one side and green on the other) - of course you can have green with blue at a later date but I find it easier to share the initial belt with the first two sciences.

Zimme2579
Burner Inserter
Burner Inserter
Posts: 12
Joined: Wed Apr 15, 2015 2:05 am
Contact:

Re: Automated Red/Green Science

Post by Zimme2579 »

SirRichie wrote:Just a curious question: is this a design from the editor? Usually, one does not have access to express belts before some serious science automation
Sort of. it is a screen shot form a world where i cheat heavily to come up with designs for factories which i then make blupes of and import to other worlds.

Ohlmann
Long Handed Inserter
Long Handed Inserter
Posts: 67
Joined: Tue Jun 10, 2014 11:22 am
Contact:

Re: Automated Red/Green Science

Post by Ohlmann »

It seem overengineered.

Normally, the consumption of even a lot of labs and science pack factory is so low that I can just use the normal stream of inserter, belts and all and take what is needed.

Zimme2579
Burner Inserter
Burner Inserter
Posts: 12
Joined: Wed Apr 15, 2015 2:05 am
Contact:

Re: Automated Red/Green Science

Post by Zimme2579 »

Ohlmann wrote:It seem overengineered.

Normally, the consumption of even a lot of labs and science pack factory is so low that I can just use the normal stream of inserter, belts and all and take what is needed.
What do you mean by normal stream?

Post Reply

Return to “Show your Creations”