Page 1 of 1

Nullius ore configuration

Posted: Tue Jun 15, 2021 8:15 am
by Anachrony
I've attached an RSO config file for the Nullius overhaul:
(1.76 KiB) Downloaded 135 times
I included it in mainconfig.lua after fillBztungstenConfig, with the following line:

Code: Select all

	if game.active_mods["nullius"] then
		config["enemy-base"] = nil
It disables biters automatically, since that's part of the setting and they won't work with this overhaul.

Re: Nullius ore configuration

Posted: Tue Jun 15, 2021 6:19 pm
by orzelek
I'll try to add it this week and release new version.

Are you disabling enemies in vanilla?
I think RSO should pick that up properly and don't need disabling enemies here. If it doesn't work I might need to fix that part.

Re: Nullius ore configuration

Posted: Tue Jun 15, 2021 6:31 pm
by Anachrony
Yes, Nullius normally removes biters without RSO, without regard for the setting. With RSO, there were biters, so I had to add that line.

Quite possibly there is another way to disable them on the Nullius side that would work better for RSO. I don’t know of other precedents of overhauls that don’t work with biters, so it may be an unusual situation. I initially tried to get the game to hide the enemy setting entirely, but had trouble getting the game to do that.

Re: Nullius ore configuration

Posted: Sat Jun 19, 2021 8:56 pm
by orzelek
I would think that RSO should react properly if you set enemy base autoplace to nil but didn't check that one. For some reason autoplace is actually ignored for enemies specifically - must had a reson for that at some point.
Added your config and base removal and it works - released 6.2.8 with it.

Re: Nullius ore configuration

Posted: Sun Jun 20, 2021 3:01 am
by Anachrony
Thank you!