screen shot of assembler and inserter highlighted
screenshot
[16.16] Stack inserter througput dropped from belt turn
-
dogbert514
- Manual Inserter
- Posts: 3
- Joined: Fri Jan 05, 2018 8:24 pm
- Contact:
[16.16] Stack inserter througput dropped from belt turn
I have a save from 16.12 where I have two stack inserters saturating a beaconed copper cable assembler. When loaded into 16.16 the throughput of this drops. After investigating I found that it was caused by one of the inserters pulling from the inside of a curved belt and failing to pickup items. When the belt is turned the other way the inserter works again.
screen shot of assembler and inserter highlighted
screen shot of assembler and inserter highlighted
- Attachments
-
- mods.zip
- Mods used in both saves
- (12.25 MiB) Downloaded 46 times
-
- testing land gc 3.zip
- 16.16 version of base. The copper belts are rotated and production is back at 16.12 baseline
- (7.7 MiB) Downloaded 43 times
-
- testing land gc 2.zip
- 16.12 version of base. When loaded wait ~2min for production to drop
- (7.67 MiB) Downloaded 47 times
Re: [16.16] Stack inserter througput dropped from belt turn
Thanks for the report. Inserters have always had trouble picking up from belt curves because the amount of items on the curve are small and move beyond the curve quickly.
If you don't want to deal with that you need to not set them up to grab from corners.
If you don't want to deal with that you need to not set them up to grab from corners.
If you want to get ahold of me I'm almost always on Discord.