Page 1 of 1
[2.0.12] Underground belts not getting placed when manually dragging belts over blueprint (MR)
Posted: Tue Oct 29, 2024 4:09 pm
by josenostoy
Only the first underground belt in the direction of the drag is placed, meaning that if I drag to the right, this happens.
- Blueprint.
- Captura 1.PNG (552.92 KiB) Viewed 1070 times
- When placing belts dragging to the right.
- Captura 2.PNG (547.22 KiB) Viewed 1070 times
If drag to the left, the other underground belts are placed instead. It doesn´t matter the direction of the belts, so if you drag to the right and to the left all underground belts are placed properly.
Re: [2.0.12] Underground belts not getting placed when manually dragging belts over blueprint (MR)
Posted: Fri Nov 01, 2024 7:23 pm
by Muche
Re: [2.0.12] Underground belts not getting placed when manually dragging belts over blueprint (MR)
Posted: Sat Nov 02, 2024 6:56 am
by jmkool
I'm experiencing a related bug. Dragging underground belts (even without BPs) suddenly stopped placing the second one. It was working earlier this very session, not sure what changed (maybe that I'm dragging it across another belt). It seemed to act as if I had started a new belt-drag the moment the first underground placed but before the second one did (in that moment of retroactively placing them across an obstacle), because it also reset my belt direction at that moment and due to probably coincidental timing left me dragging a belt in the opposite directionality. Bug occurred with yellow belts, in case that's relevant somehow. It did happen two times back to back.
Version 2.0.13-1, Vulcanis.
Re: [2.0.12] Underground belts not getting placed when manually dragging belts over blueprint (MR)
Posted: Sat Nov 02, 2024 12:33 pm
by Loewchen
jmkool wrote: ↑Sat Nov 02, 2024 6:56 am
...
Sounds like
116892, there are many issues with underground belts and they will be kept separate so nothing is overlooked.
Re: [2.0.12] Underground belts not getting placed when manually dragging belts over blueprint (MR)
Posted: Sat Nov 02, 2024 2:26 pm
by cebacci62
in my experience, the issue occurs only when the belt dragging construction is done in the same direction as the belt (in the example from the photo, from left to right). When building in the opposite direction, it works fine.
Re: [2.0.12] Underground belts not getting placed when manually dragging belts over blueprint (MR)
Posted: Sat Nov 30, 2024 10:18 pm
by Cobaltur
Still an annoying issue in 2.0.21 stable.
And dragging the line from the opposite does not work for me. All the time the 2nd part is not placed independent of the direction I build.