Railbuilder - Autoconnect two rails

[scooter010]

I tried to connect two railway networks, without a railroad cross. The (double) rail come together straight from North and South. But the rails didn't hit each other, they are some few tiles (2) away from each other.

I found out, that it's very difficult to connect these rails with the railbuilder. It needed 2 curves per line to connect them over a distance which is longer than the normal build distance. And it took me 10 minutes, just to toggle the needed curve left and right. Was annoying.

Is there any chance, that there will be an Autoconnect feature for two rails into the direction?

[DaleStan]

It would be easier if you'd included a screenshot, but I think the search term you were looking for is "S-Curve".

34925, 19953