Page 1 of 1
[0.13] Pipe to Circuit Network
Posted: Wed Jun 29, 2016 10:40 pm
by saturn7
One thing that apparently cannot be connected to the circuit network is the pipe.
Incidentally it was the first thing I tried to connect in 0.13
(for balancing the petroleum between plastic and sulfur).
Would be great if that could be added!
Re: [0.13] Pipe to Circuit Network
Posted: Thu Jun 30, 2016 7:13 am
by Neotix
You can connect Tank.
Re: [0.13] Pipe to Circuit Network
Posted: Thu Jun 30, 2016 7:15 am
by gheift
Or the small pump to control the flow.
Re: [0.13] Pipe to Circuit Network
Posted: Thu Jun 30, 2016 12:30 pm
by saturn7
I know, but it would be nice to read out the content of the pipes directly, without the side effect of tanks and pumps.
Re: [0.13] Pipe to Circuit Network
Posted: Thu Jun 30, 2016 2:37 pm
by ssilk
When I remember right it was on the list of things Twinsen wanted to implement for the circuit network.
Piping Circuit Network
Posted: Fri Jul 01, 2016 2:14 am
by soren82002
Joined into this older thread (hum, only one day older) -- ßilk
When working on a circuit network on a server, I noticed that the only way to get a reading on how much liquid we had flowing in pipes was to put down a tank and measure that. Pumps can only be turned on and off, and you can't connect wires to pipes. This doesn't make much sense, because we can connect to transport belts.