Page 1 of 1

[1.1.70] Flip does not work on hazard concrete

Posted: Wed Nov 02, 2022 4:20 pm
by JasonC
The flip command does not affect hazard concrete's orientation.

Steps:
1. Put a hazard concrete ghost in hand (such as a single piece, or a paste/bp containing one or more hazard concretes)
2. Use the flip command

Expected: Hazard concrete pattern flipped left-to-right i.e. reversed, rotated, whatever you'd like to call it.

Actual: Hazard concrete pattern stays the same.

Workaround: There is none. If you have a bp containing hazard concrete and you wish to flip it including the hazard pattern, each piece must be rotated manually after placement.

Re: [1.1.70] Flip does not work on hazard concrete

Posted: Thu Nov 03, 2022 5:57 pm
by Rseding91
Thanks for the report however flip does not currently interact with tiles in any way. Moving to ideas and suggestions.

Re: [1.1.70] Flip does not work on hazard concrete

Posted: Fri Nov 04, 2022 12:04 am
by JasonC
Rseding91 wrote:
Thu Nov 03, 2022 5:57 pm
Thanks for the report however flip does not currently interact with tiles in any way. Moving to ideas and suggestions.
Sounds good. Rotate works so it seems reasonable for flip to work, too.