[0.18.33] Rail planner selection box is asymetrical
Posted: Wed Jun 24, 2020 9:34 pm
You can enter rail planner mode by holding a rail in your hand and then clicking on an existing rail piece. When you hover over two connected existing rail piece, the selection box for rail planner heading north is bigger than the one heading south.
Green: Selectionbox south, Yellow: Selectionbox north
I was expecting the selection boxes for both directions to be equally big. It's probably caused by the selection boxes of both rails overlapping, so it would maybe make sense to just shrink the selection boxes to properly represent the occupied tiles instead of the graphic.
Green: Selectionbox south, Yellow: Selectionbox north
I was expecting the selection boxes for both directions to be equally big. It's probably caused by the selection boxes of both rails overlapping, so it would maybe make sense to just shrink the selection boxes to properly represent the occupied tiles instead of the graphic.