Page 1 of 1

[0.16.51] Fluids inside pipe bends are lower than outside

Posted: Fri Aug 31, 2018 8:01 pm
by Jon8RFC
Not a weird setup of multiple pumps, merging pipes, etc...just a bend of two pipes.
https://youtu.be/q5ZZs2KX_hw


The save doesn't have the removed connecting pipes, but I removed them for the video.

Re: [0.16.51] Fluids inside pipe bends are lower than outside

Posted: Sun Sep 23, 2018 10:31 pm
by Rseding91
Thanks for the report however I'm going to say this isn't going to be fixed.

The fluid logic "works" for the most part. It doesn't have any preference for a given direction over another however the order you build pipes can effect fluid flow.

This may all change at some point in the future but for now we're not going to spend any time on this.