Page 1 of 1
[16.25] Steam turbine in two switch connected networks counted twice
Posted: Sat Feb 24, 2018 1:11 pm
by Fishy
When a Big Electric Pole is connected to my nuclear power plant through a power switch, if the supply area of the big electric pole touches a steam turbine, it is counted twice in the electrical interface screen when the switch is turned on. Didn't check for other power poles.
Re: Steam turbine counted twice in Electrical interface
Posted: Sat Feb 24, 2018 1:24 pm
by Loewchen
Post log and save please.
Re: [16.25] Steam turbine in two switch connected networks counted twice
Posted: Sat Feb 24, 2018 6:16 pm
by Fishy
Happens with any configuration of power poles and power sources.
Re: [16.25] Steam turbine in two switch connected networks counted twice
Posted: Sun Feb 25, 2018 2:06 pm
by Rseding91
Thanks for the report however that's working correctly. It shows up twice because it's in both networks. It however doesn't produce any more or less power because of it being in both networks.
To change that is non-trivial and would add additional performance overhead to electric logic so we're not going to change it.