Page 1 of 1
I made a spreadsheet for Assembler ratios
Posted: Tue Aug 11, 2015 3:52 pm
by bigyihsuan
Link to the spreadsheet
Feel free to edit and add on to it. I have a feeling that some ratios are wrong, except for you needing only 1 Copper Wire Assembler for 8 Red Circuit assemblers, and the 3 CC to 2 EC/GC ratio.
EDIT: Currently, it's only Green and Red circuits so far, since those are the only one's I'm sure of.
Re: I made a spreadsheet for Assembler ratios
Posted: Tue Aug 11, 2015 10:37 pm
by bigyihsuan
Changelog:
[*] Added Steel, Iron/Copper Plate, all Inserters, Gears
Re: I made a spreadsheet for Assembler ratios
Posted: Wed Aug 12, 2015 10:07 pm
by Peter34
bigyihsuan wrote:Link to the spreadsheet
Feel free to edit and add on to it. I have a feeling that some ratios are wrong, except for you needing only 1 Copper Wire Assembler for 8 Red Circuit assemblers, and the 3 CC to 2 EC/GC ratio.
EDIT: Currently, it's only Green and Red circuits so far, since those are the only one's I'm sure of.
1 Copper Cable-> 8 Red Circuit is a well established ratio. Likewise 3:2 for Green Circuit. So no, your arithmetic isn't wrong for those two.
Some months ago, I did some data collection of my own, although I were much less interested in the ratios than I were in what was actually needed to build various items. I was looking for commonalities, and I was also looking for (or, at any rate, I found) misconceptions of my own, e.g. with regards to materials that I thought were widely used but which were in fact only ever used for a very few things, such as Plastic (keep in mind, this was for alpha 11), and which therefore
shouldn't be put into any material loops.