Page 1 of 1

[17.68] Connections between electric poles are incorrectly copied

Posted: Sun Sep 08, 2019 6:10 pm
by addaco
connections between electric poles are incorrectly copied

simple example:

1) I create 2 electric poles and eliminate the connection between them
2) I'm trying to copy them

result:
two electric poles created connected by a cable

expected:
two poles created not connected to each other. Just like the pattern was built

Re: [17.68] Connections between electric poles are incorrectly copied

Posted: Sun Sep 08, 2019 6:21 pm
by Loewchen
Wire connections are not stored in blueprints.

Re: [17.68] Connections between electric poles are incorrectly copied

Posted: Sun Sep 08, 2019 6:22 pm
by tehfreek
Only electrical connections to power switches are copied. Every other possible connection is recalculated dynamically on constructing the entities.

Re: [17.68] Connections between electric poles are incorrectly copied

Posted: Sun Sep 08, 2019 6:36 pm
by addaco
I understand, but this makes it difficult to copy switch-based schemes.

Example below. I created logic that only charges the battery when the energy drops below 80% and then charges to 100%. Then it waits again until it drops to 80 e.t.c. The copied logic will not work properly because of generated connections between electric poles