[Wheybags] [0.17.33] Rich text tags break in blueprints
Posted: Fri Apr 26, 2019 4:23 pm
What did you do?
- Create a blueprint/blueprint book with rich text tags where the end tag would be cut off due to truncation
What happened?
- The beginning part of the tag is displayed and whatever text was afterwards
What did you expect to happen instead? It might be obvious to you, but do it anyway!
- The color tags should potentially be bumped forward so they properly terminate, or they should be stripped altogether so that the text can still be read.
In the screenshot the blueprint named 'Linear x 8' has the color yellow and because it is short enough it works fine. The one called 'Tessellate x42' however is too long, and the color tag shows up and is flowing over the other blueprint and it isn't properly truncating/abbreviating. Without color the blueprint will abbreviate just fine. If whatever tags were started in the text could be ignored, and then properly terminated after the truncation it would look potentially better.
- Create a blueprint/blueprint book with rich text tags where the end tag would be cut off due to truncation
What happened?
- The beginning part of the tag is displayed and whatever text was afterwards
What did you expect to happen instead? It might be obvious to you, but do it anyway!
- The color tags should potentially be bumped forward so they properly terminate, or they should be stripped altogether so that the text can still be read.
In the screenshot the blueprint named 'Linear x 8' has the color yellow and because it is short enough it works fine. The one called 'Tessellate x42' however is too long, and the color tag shows up and is flowing over the other blueprint and it isn't properly truncating/abbreviating. Without color the blueprint will abbreviate just fine. If whatever tags were started in the text could be ignored, and then properly terminated after the truncation it would look potentially better.