Page 1 of 1
[0.15.6] No steam option in circuit network signals
Posted: Thu May 04, 2017 2:44 am
by Blacksmoke16
I am using Flow Control's valves to route steam to store it for emergencies. I then went to wire up a speaker to broadcast an alert if the amount of steam amount in the valve was below a certain value, but there is no steam option when selecting the circuit networks signal options.
Re: [0.15.6] No steam option in circuit network signals
Posted: Thu May 04, 2017 7:23 am
by NiallTorint
Water and steam are the same fluid.
Re: [0.15.6] No steam option in circuit network signals
Posted: Thu May 04, 2017 9:38 am
by Loewchen
This might change, but for now it is NaB.
Re: [0.15.6] No steam option in circuit network signals
Posted: Sun May 07, 2017 11:12 am
by Loewchen