Page 1 of 1

Rail planner behaves strangely on two-level self-intersection

Posted: Sun Nov 10, 2024 7:43 pm
by untech
In the attached video, I recorded abnormal behavior of the rail planner. When in planning mode, it allows to make an intersection between rail ramp and elevated rail. However, after clicking, the ramp disappears. Afterwards, you can't plan a ramp in the same spot.

My Factorio version is 2.0.15.

Relevant screenshots from the video:
11-10-2024, 23-41-57.png
11-10-2024, 23-41-57.png (3.62 MiB) Viewed 135 times
11-10-2024, 23-42-29.png
11-10-2024, 23-42-29.png (3.53 MiB) Viewed 135 times

Re: Rail planner behaves strangely on two-level self-intersection

Posted: Sun Nov 10, 2024 10:50 pm
by boskid