[2.0.14] Ghost rail planner tries to place intersecting supports
Posted: Sat Nov 02, 2024 11:24 pm
When building elevated rails, the ghost rail planner can sometimes try to place two supports that intersect each other. Attempting to build anyway will not build the whole rail. I believe this is caused by the rail planner not testing for self-intersection.
Here is video of the simplest scenario I've found that triggers the behavior (first few seconds are black from starting the recording): However, while this was a special case, it usually happens when the rail planner is attempting to build some kind of looping maneuver
Video was taken in 2.0.13, but I switched to 2.0.14 experimental to see if it still happened. It does.
Here is the save where the video was taken from:
Here is video of the simplest scenario I've found that triggers the behavior (first few seconds are black from starting the recording): However, while this was a special case, it usually happens when the rail planner is attempting to build some kind of looping maneuver
Video was taken in 2.0.13, but I switched to 2.0.14 experimental to see if it still happened. It does.
Here is the save where the video was taken from: