[2.0.13] Super Force build balancer over existing belts incorrect
Posted: Sat Nov 02, 2024 3:13 pm
steps: Build four belts side by side long enough to place a typical 4 belt balancer on. Super force build the balancer (place an item in the gaps of the balancer).
expected: your 4 belt bus now has a balancer.
actual: The preview for super force build looks correct (middle image) but the placed ghosts (and actual result) is wrong (right hand image).
There are two issues here. 1) the preview doesn't match the result. 2) the result is not what was intended. That later could just be a quirk of the mechanics and that's just the way it is. But I'd argue this will be a very common use of super force build and so would be good to support. The former however is definitely a bug.
Another slight quirk of the preview is the two belts that come out of the middle splitter (the splitter between the two chests). The right hand belt shows the curve, the left one is just horizontal.
expected: your 4 belt bus now has a balancer.
actual: The preview for super force build looks correct (middle image) but the placed ghosts (and actual result) is wrong (right hand image).
- 11-02-2024, 12-13-37.png (1.53 MiB) Viewed 158 times
Another slight quirk of the preview is the two belts that come out of the middle splitter (the splitter between the two chests). The right hand belt shows the curve, the left one is just horizontal.