The input signal for the pump and inserter inserter is not showing
when we use a combinator and connect it with red or green wire, it shows the input signals it receives.
The inserter also has the option to enable / disable based on a condition, when connected with a red/green wire, but but the input signals received by a inserter/pump is not shown when connected with a red/green wire .
[0.18.1] input signals for inserter and pump is not shown
-
varundevan
- Fast Inserter
- Posts: 173
- Joined: Mon Jan 20, 2020 4:41 am
- Contact:
[0.18.1] input signals for inserter and pump is not shown
Last edited by varundevan on Thu Feb 13, 2020 8:48 am, edited 3 times in total.
