Factorio Forums

Hello,

i may have stumbled at a bug with trains - sheduling/enable station.....

I have some trains which throws a 'no path' in mid travel...

This trains have only two stations oil load (3 stations, all the same name) and oil drop off (one station).
oil drop off condition is : when empty
oil load condition is : when full

oil drop off is always enabled
oil load is only enabled if the attached tank is full enough to fill a whole train (currently 2 tanks & one tank-trailer)

there are currently 2 such trains, and it seems that all two trains go for a(the same) enabled station, and after one train is full the station is disabled.
so that leaves the secund train without the next stop, because its enabled.

even if two such stations are enabled the secound train give the avove error 'no path' on the way to the formerly enabled station and stops in midtrack.
-> this train should be rerouted to the secound enabled station or to the other station which is always enabled.

Do you have another station named "oil load" on a different rail network? If that's the case, it's not a bug but is intended behavior because the station is enabled but is in fact unreachable.

knightelite wrote: ↑Wed Apr 17, 2019 10:20 pm Do you have another station named "oil load" on a different rail network? If that's the case, it's not a bug but is intended behavior because the station is enabled but is in fact unreachable.

Could you deny or confirm this?
If so, could you provide a save?
Moving to pending until we get more info.