[0.16.51] Ghost of constant combinator wont set signals

[joshinils]

I have put down a blueprintghost of some circuitry where some constant combinators are set to some signals.
the problem is that when i place down the constant combinator by hand the signals wont be set. whereas i would expect them to be.
weirdly after placing the decider (the signal is sent to from the constant) and then afterwards place the constant, the constant will have its signals set.

it depends on the order i place constant combinators whether their signals get set from the ghost or not.
if nothing is connected in the ghost to the constant they also wont get set.

similar to viewtopic.php?f=23&t=55547&p=326723&hil ... or#p326723

(this is especially annoying if im building constant combinator based signs which obviously dont connect to anything)

[Loewchen]

Can not reproduce, post save and exact steps to reproduce please.

[Rseding91]

Can not reproduce, post save and exact steps to reproduce please.

Yes please.