Factorio Forums

Posted: **Fri Feb 10, 2017 5:32 pm**

When setting an arithmetic combinator, the "Or set a constant" box does not display anything when you type a hyphen.
Upon clicking "Set", it will correctly assign a negative, and display correctly on the Summary GUI, however, upon bringing up the configuration GUI again, the hyphen is once again not visible.

: negative 1.PNG (577.76 KiB) Viewed 2955 times

This was not an issue in 0.13, and appears to be a regression introduced at some point in 0.14.

Posted: **Fri Feb 10, 2017 6:09 pm**

Works fine for me. Please post your log file to see what system you use.

screenshot

Posted: **Sat Feb 11, 2017 3:35 am**

Log file attached.

Posted: **Sat Feb 11, 2017 5:34 am**

What hyphen character are you typing?

I use - (ASCII 45)

Posted: **Sat Feb 11, 2017 6:06 am**

DaveMcW wrote:What hyphen character are you typing?

I use - (ASCII 45)

I am using the same character. U+002D HYPHEN-MINUS (ASCII 45)

Posted: **Fri Mar 17, 2017 11:34 am**

Can't reproduce the issue.
Keep in mind that that the slider goes from 1 to 2000000000, in case you are moving the slider.

Factorio Forums

[14.22] Combinator does not display hyphen in Signal selection UI

[14.22] Combinator does not display hyphen in Signal selection UI

Re: [0.14.22] Arithmetic Combinator does not display negatives

Re: [0.14.22] Arithmetic Combinator does not display negatives

Re: [0.14.22] Arithmetic Combinator does not display negatives

Re: [0.14.22] Arithmetic Combinator does not display negatives

Re: [14.22] Combinator does not display hyphen in Signal selection UI