[1.1.70] Some blueprints cropped in bp editor (new bp only)
Posted: Sun Oct 30, 2022 10:19 pm
I ran into a blueprint that was cropped by the editor window. I've never seen this happen, usually the scaling and centering is correct. Not sure what the cause is; maybe the pipes aren't being included in the size calculation? But that wouldn't expain why the chemical plant in the image below is a little to the left of center.
Yields:
What I did:
1. Activated blueprint tool in game
2. Selected some stuff I already had placed
Expected: New blueprint window with entire selection scaled and centered to fit in editor view.
Actual: Left side is cropped off in editor view.
Note: This is in the initial new blueprint window. Once I saved the blueprint then opened it again, the problem no longer appeared. However, when I again created a new blueprint and selected these objects, the same issue appeared.
Yields:
- Image1.png (197.53 KiB) Viewed 704 times
1. Activated blueprint tool in game
2. Selected some stuff I already had placed
Expected: New blueprint window with entire selection scaled and centered to fit in editor view.
Actual: Left side is cropped off in editor view.
Note: This is in the initial new blueprint window. Once I saved the blueprint then opened it again, the problem no longer appeared. However, when I again created a new blueprint and selected these objects, the same issue appeared.