[boskid][1.1.104] Light on circuit disconnect does not revert to logistic network setting

Post Reply
AdamTReineke
Manual Inserter
Manual Inserter
Posts: 1
Joined: Sat Mar 09, 2024 9:09 am
Contact:

[boskid][1.1.104] Light on circuit disconnect does not revert to logistic network setting

Post by AdamTReineke »

Video showing the bug on a different save - https://youtu.be/VkzOtKQAqq4

I created and attached a minimum save game using Rocket Rush mode for easy setup and cheated in an infinite accumulator.

1. Load the save game, make sure it's daytime (far left light should be off).

-- The first light is not on any network, off because it's daytime.
-- The second light is on the logistics network, on because the condition is true.
-- The third light was added to the logistics network same as second light, then connected to the constant combinator. On because wired condition is true.
-- The fourth light is in the bugged state already. It was set up like the third light and then the wire was disconnected. It is "turned off during daytime".

2. Disconnect the third light's red wire from the constant combinator.

Expected: The third light should reconnect to the logistics network and be on and white.
Actual: The third light is off. The UI for the light shows that it is connected to the logistics network.
Attachments
factorio-current.log
(5.42 KiB) Downloaded 18 times
light-bug-on-disconnect.zip
(1.32 MiB) Downloaded 18 times

User avatar
boskid
Factorio Staff
Factorio Staff
Posts: 2318
Joined: Thu Dec 14, 2017 6:56 pm
Contact:

Re: [boskid][1.1.104] Light on circuit disconnect does not revert to logistic network setting

Post by boskid »

Thanks for the report. Issue will be fixed in 2.0.

Post Reply

Return to “Fixed for 2.0”