I have the inserters controlled by circuit from the train stop with "Read Train Contents". Works fine.
When adding (or removing) a wagon to the train, it stops reporting the content. (This caused inserters to start loading again)
I can set it manual, reverse it a little and then schedule that stop again, and now the content is being reported again.
This was also experienced in 1.0 (but I was unsure what I had done)
[1.1.13] Train content to circuit stops when adding wagons
[1.1.13] Train content to circuit stops when adding wagons
- Attachments
-
- factorio-current.log
- (5.47 KiB) Downloaded 74 times
+---+
| M | (now 2000+ hours)
+---+
| M | (now 2000+ hours)
+---+
Re: [1.1.13] Train content to circuit stops when adding wagons
Not a bug. If you modify a train it becomes a new train with a new train ID, and it is not stopped at the station anymore.
You could make a proposal for a change in the suggestions forums.
You could make a proposal for a change in the suggestions forums.
Re: [1.1.13] Train content to circuit stops when adding wagons
Indeed, it basically moves out of the automatic mode by this.