[0.18.26] [Transport Drones+Seablock] Coolant Temperature getting lost when transported by drones
Posted: Mon May 25, 2020 6:11 am
The attached savefile has me standing next to the used coolant requester. When a drone arrives carrying coolant, the coolant is either 300 (expected) or 25 (cooled off significantly during transit), possibly dependent on whether it is a full load or not, but I can't seem to pick which is which.
If you attach a pipe to the output of the requester, you can read the temperature, attach to the tank to drain the requester and then delete pipes before the next drone arrives to test. Each load is either 300 or 25, nothing in between.
If you attach a pipe to the output of the requester, you can read the temperature, attach to the tank to drain the requester and then delete pipes before the next drone arrives to test. Each load is either 300 or 25, nothing in between.
