[0.18.10] Backing-up train when sitting in cargo has swapped L/R sides
Posted: Fri Mar 06, 2020 3:34 pm
Left and right sides (controls) are swapped when backing-up a train while sitting in any cargo.
When in locomotive this doesn't occur.
Steps to reproduce:
When sitting in a train
LCCCCC(CCC)
but i was sitting in a, lets say middle C (here its copper)
and backing up into a Y section
the turning controls seem reversed
(I was driving from south to north (bottom of the Y), wanted go to west branch, so I pressed S+D, but the train was going East branch
when later i disconnected only Locomotive, it was going S+D West (right hand branch (of riding direction)) and S+A East(left hand branch))
When in locomotive this doesn't occur.
Steps to reproduce:
When sitting in a train
LCCCCC(CCC)
but i was sitting in a, lets say middle C (here its copper)
and backing up into a Y section
the turning controls seem reversed
(I was driving from south to north (bottom of the Y), wanted go to west branch, so I pressed S+D, but the train was going East branch
when later i disconnected only Locomotive, it was going S+D West (right hand branch (of riding direction)) and S+A East(left hand branch))