Page 1 of 1
[0.18.2] Trains do not skip station if all are deactivated
Posted: Tue Jan 28, 2020 6:08 pm
by Patus
When you have multiple train stations with same name and if circuit network set every station disable then every trains that was on its way to the station will stop and complain "Path not find".
Previous versions trains skip disabled station and go back first one.
Re: [0.18.2] Trains do not skip station if all are deactivated
Posted: Tue Jan 28, 2020 9:12 pm
by Blacky007
are you sure the trains can go back to first station?
Re: [0.18.2] Trains do not skip station if all are deactivated
Posted: Tue Jan 28, 2020 11:00 pm
by boskid
I am trying to reproduce this but it works fine. Could you post your save file? Only case i could cause above mentioned issue is by having enabled disconnected extra train stop that was making station still available.
Re: [0.18.2] Trains do not skip station if all are deactivated
Posted: Wed Jan 29, 2020 12:26 am
by Patus
This happens copper and iron plate trains. When train get stuck and complain "no path", train can manually go back by selecting previous station. Previous version this train setup is working fine.
- No path
- train bug.png (4.48 MiB) Viewed 1677 times
save file
https://www.dropbox.com/s/xb4xf6m4ojw3ico/Save.zip?dl=0
Re: [0.18.2] Trains do not skip station if all are deactivated
Posted: Wed Jan 29, 2020 12:34 am
by boskid
- 80566-not-a-bug.png (35.5 KiB) Viewed 1673 times
1/ Missing rail
2/ Still enabled Copper Plate Out
Not a bug.
Re: [0.18.2] Trains do not skip station if all are deactivated
Posted: Wed Jan 29, 2020 12:51 am
by Patus
Thanks. If map has any not connected trains station with same name trains not skip stations.
Re: [0.18.2] Trains do not skip station if all are deactivated
Posted: Wed Jan 29, 2020 9:42 am
by Blacky007
additional info:
better set train-signal after junction and train-chain-signal in front of the junction to not block trains moving from left to rigth
Greeting Blacky007