When you have multiple train stations with same name and if circuit network set every station disable then every trains that was on its way to the station will stop and complain "Path not find".
Previous versions trains skip disabled station and go back first one.
[0.18.2] Trains do not skip station if all are deactivated
Re: [0.18.2] Trains do not skip station if all are deactivated
are you sure the trains can go back to first station?
My color birthday was May 2nd 2020 - Thank you Enchroma
Re: [0.18.2] Trains do not skip station if all are deactivated
I am trying to reproduce this but it works fine. Could you post your save file? Only case i could cause above mentioned issue is by having enabled disconnected extra train stop that was making station still available.
Re: [0.18.2] Trains do not skip station if all are deactivated
This happens copper and iron plate trains. When train get stuck and complain "no path", train can manually go back by selecting previous station. Previous version this train setup is working fine.
save file
https://www.dropbox.com/s/xb4xf6m4ojw3ico/Save.zip?dl=0
save file
https://www.dropbox.com/s/xb4xf6m4ojw3ico/Save.zip?dl=0
Re: [0.18.2] Trains do not skip station if all are deactivated
2/ Still enabled Copper Plate Out
Not a bug.
Re: [0.18.2] Trains do not skip station if all are deactivated
Thanks. If map has any not connected trains station with same name trains not skip stations.
Re: [0.18.2] Trains do not skip station if all are deactivated
additional info:
better set train-signal after junction and train-chain-signal in front of the junction to not block trains moving from left to rigth
Greeting Blacky007
better set train-signal after junction and train-chain-signal in front of the junction to not block trains moving from left to rigth
Greeting Blacky007
My color birthday was May 2nd 2020 - Thank you Enchroma