Page 1 of 1
Train Signal doesnt work when placed after selecting with Strg+C
Posted: Thu Aug 22, 2019 3:17 pm
by alkistnieda
The title pretty much says it all; When I let my robots build a train signal next to a rail; it simply doesnt work. Removing and placing via hand fixes it. The problem only accounts for train signals, not chain signals.
Re: Train Signal doesnt work when placed after selecting with Strg+C
Posted: Thu Aug 22, 2019 3:20 pm
by Loewchen
Chances are, you failed to actually connect it to the rail. If you are sure that is not the case post a link to the save.
Re: Train Signal doesnt work when placed after selecting with Strg+C
Posted: Thu Aug 22, 2019 3:27 pm
by alkistnieda
I just tried it again; I placed it correctly and the signal doesnt work. The save-file is 71MB, whats your preferred way of uploading?
Re: Train Signal doesnt work when placed after selecting with Strg+C
Posted: Thu Aug 22, 2019 3:28 pm
by alkistnieda
Actually, I just realized I have to manually rotate the signal. My bad!