[0.17.63] Pump does not connect to fluid wagon if the Train Stop is around a curve
Posted: Thu Aug 08, 2019 5:34 pm
Please take a look at the picture below
Factorio Forums
www.factorio.com
https://forums.factorio.com/
[0.17.63] Pump does not connect to fluid wagon if the Train Stop is around a curve
Page 1 of 1
Re: [0.17.63] Pump does not connect to fluid wagon if the Train Stop is around a curve
Posted: Thu Aug 08, 2019 5:51 pm
Hello, thank you for taking the time to post the bug report, however this is intentional due to complicated graphics of pump connector, it won't connect to fluid wagons unless they are aligned to particular position and train stopped on curve doesn't have correct alignment.
Re: [0.17.63] Pump does not connect to fluid wagon if the Train Stop is around a curve
Posted: Thu Aug 08, 2019 6:09 pm
Yes I was aware of the fact, that the pump is not connected if the fluid wagon is on a curve. However I didnt know that they wont connect if any part of the train is standing inside a curve. I thougt my problem was not intended...posila wrote: ↑Thu Aug 08, 2019 5:51 pm Hello, thank you for taking the time to post the bug report, however this is intentional due to complicated graphics of pump connector, it won't connect to fluid wagons unless they are aligned to particular position and train stopped on curve doesn't have correct alignment.
