Overlapping rail signal positions

[Trebor]

Sometimes when rails cross the position of rail signals is ambiguous, that is the position looks like it could be for more then one track. If a signal is placed at that position it only controls one of the rails. The problem is you have no control over which rail the signal will control.

Screen Shot 2018-09-22 at 12.01.08 AM.png (546.66 KiB) Viewed 1357 times

I propose three solutions, please pick one:

1) Signal controls all rails.
2) Allow player to select which rail signal controls.
3) Remove display of signal (line connecting position to rail) for rails that signal does not control.

[Rseding91]

Thanks for the report however you already can control which rail it connects to by pressing "R" to rotate the signal before you build it at that location.

[Trebor]

Boy do I feel dumb. I never tried to rotate the signal. Is this in a rail tutorial?

[Jap2.0]

Thanks for the report however you already can control which rail it connects to by pressing "R" to rotate the signal before you build it at that location.

TIL, I always had to remove rails to try to get it to fit.