[Twinsen][0.16.x] Inserter block each other
Posted: Fri Jan 05, 2018 12:17 pm
If there are two stack-Inserter feeding a production maschine 3 with kopperplates to create copper wire it happen at about 20-30% of the time
while double loading that on inserter blocks the second or both inserter block each other
the moment one is taking the plates from belt the second one stops for a short moment and then it goes on.
if you have runnung the maschine at a high speed you often run out of copperplates for half a second.
a stack inserter need time to pick the 12 plates. I use a fast inserter and a stack inserter together to reduces this stop window.
but then the stack inserter is getting into short breaks because the fast inserter is picking his plates from the belt.
I think that it doesn't matter what productivity or speedmodules are used.
my usecase where I can see this bug is productivity = 40% and speed is 4,25 (240%) or with 2,375 (+90%).
I have a bluebelt full of copperplates.
I think that you will see the same bug with 3 or more inserter working together.
I play at 0.16.12
while double loading that on inserter blocks the second or both inserter block each other
the moment one is taking the plates from belt the second one stops for a short moment and then it goes on.
if you have runnung the maschine at a high speed you often run out of copperplates for half a second.
a stack inserter need time to pick the 12 plates. I use a fast inserter and a stack inserter together to reduces this stop window.
but then the stack inserter is getting into short breaks because the fast inserter is picking his plates from the belt.
I think that it doesn't matter what productivity or speedmodules are used.
my usecase where I can see this bug is productivity = 40% and speed is 4,25 (240%) or with 2,375 (+90%).
I have a bluebelt full of copperplates.
I think that you will see the same bug with 3 or more inserter working together.
I play at 0.16.12