[2.0.13] Tooltip shows % increase of pollution from productivity, but not % decrease from efficiency modules
Posted: Thu Oct 31, 2024 7:04 pm
Hi! In the current version of Factorio, things like max electricity consumption show the %change from baseline in the tooltip whenever modules/beacons change the value. Likewise, things like speed (mining speed in this case) also show the %change in the tooltip (-15% in this case).
Here, too, the pollution percentage is shown as being affected, in this case +15%, which is correct for three productivity 1 modules. However, this does not reflect the %change from one efficiency 1 module and two sets of beaconed efficiency 2 modules.
The pollution itself is correctly shown, but the change in percentage from the original pollution value is not: it only shows the 15% increase from the 3 productivity modules.
In short: productivity modules factor into the tooltip %change for pollution. But efficiency modules do not. This is inconsistent, and misleads to what the original pollution factor of the building is based on the % in the tooltip (here, 15% less than 9.2 is 8/m, but Big mining drills have 40/m pollution).
Here, too, the pollution percentage is shown as being affected, in this case +15%, which is correct for three productivity 1 modules. However, this does not reflect the %change from one efficiency 1 module and two sets of beaconed efficiency 2 modules.
The pollution itself is correctly shown, but the change in percentage from the original pollution value is not: it only shows the 15% increase from the 3 productivity modules.
- Two beacons with efficiency 2s affecting a miner with three prod 1s and one eff 1.
- Screenshot 2024-10-31 at 11.47.30 AM.png (4.64 MiB) Viewed 87 times