Page 1 of 1

[1.1.110] Rail signals placed with wrong rotation when using copy&paste

Posted: Tue Oct 01, 2024 4:18 pm
by Metaing
Rail (chain) signals are placed with wrong rotation when using copy&paste.
If you copy a signal from a track in one direction (eg. 45 degree angle) and paste it next to a track in another direction (eg. 0 degree) the signal keeps the original orientation. It does not rotate to the correct orientation.
The Rail signal is also blinking as not connected to a rail.

Re: [1.1.110] Rail signals placed with wrong rotation when using copy&paste

Posted: Tue Oct 01, 2024 4:53 pm
by Loewchen
Blueprinting copies orientation, that is intended.

Re: [1.1.110] Rail signals placed with wrong rotation when using copy&paste

Posted: Tue Oct 01, 2024 5:41 pm
by robot256
If you don't want the exact orientation, instead of copying the other signal, press Q to pipette it into your cursor to place normally.

Re: [1.1.110] Rail signals placed with wrong rotation when using copy&paste

Posted: Wed Oct 02, 2024 6:01 pm
by Metaing
To pipette requires you have it in your inventory. Which is kind of stupid if remote placed anyway.
Why I prefer to use the copy&paste.

Re: [1.1.110] Rail signals placed with wrong rotation when using copy&paste

Posted: Wed Oct 02, 2024 6:40 pm
by Loewchen
Metaing wrote: Wed Oct 02, 2024 6:01 pm To pipette requires you have it in your inventory. Which is kind of stupid if remote placed anyway.
Only if you specifically set it to not switch to ghosts. If you want to discuss this further, open a gameplay help topic or make a feature request.