Removing rails while in Rail Planner

[Hydro Engineer]

After setting down some Rail with Rail Planner, with rail still in hand,I right clicked on the last piece of rail to remove it. It removed the one piece of rail, but the green takeoff point arrow was still in the same place, not back at the new end of rail. When I laid down more track it started at the green arrow leaving a gap in the railway. This was easily fixed by putting the rail back in the box and starting again, but I don't think this is how the tool was intended to work. The orientation of the rail was straight up. I'm using version 0.17.50. Thanks for a great game!

[Rseding91]

Thanks for the report. That is working correctly: the rail planner just needs some "start point" and after that the start point is ignored.