Priority Splitter
Posted: Sat Sep 17, 2016 2:55 am
Found this setup for a priority splitter that seems to work well.
Preferentially outputs on the bottom lane, any overflow going to the top. The circuit conditions are read/hold on the first two, enable/anything > 12 on the low-priotity out.
The input lanes need to be balanced for this to work, which is the point of the initial splitter. They also need to be side-balanced (i.e. both sides of the belt the same), but using a hacked splitter (mod by Murdersquish) initially, or any other side-balancing setup, solves that problem.
Can be chained to enforce priority lanes on a bus.
- priority_splitter_2.png (44.77 KiB) Viewed 30188 times
The input lanes need to be balanced for this to work, which is the point of the initial splitter. They also need to be side-balanced (i.e. both sides of the belt the same), but using a hacked splitter (mod by Murdersquish) initially, or any other side-balancing setup, solves that problem.
Can be chained to enforce priority lanes on a bus.
- priority_splitter.png (1.52 MiB) Viewed 30188 times