Brownout Alarm (accumulator discharge rate sensor)

This board is to show, discuss and archive useful combinator- and logic-creations.
Smart triggering, counters and sensors, useful circuitry, switching as an art :), computers.
Please provide if possible always a blueprint of your creation.
Post Reply
Theikkru
Filter Inserter
Filter Inserter
Posts: 402
Joined: Wed Mar 27, 2019 2:18 pm
Contact:

Brownout Alarm (accumulator discharge rate sensor)

Post by Theikkru »

A simple device that you can deploy anywhere on a power network to alert you when your accumulators are nearing or at their (discharge rate) limit:
balarm.png
balarm.png (47.85 KiB) Viewed 605 times

Due to speaker limitations, the standard version stops working in deep brownouts (below 50% power satisfaction), so for more extensive coverage, there's an EX version:
balarmex.png
balarmex.png (79.66 KiB) Viewed 605 times

No solar panels needed! Just make sure the right-hand power pole doesn't connect to anything other than the switch.

Both versions will ping you audibly and with an alert based on how fast your power network is trying to drain your accumulators:
demo.png
demo.png (514.68 KiB) Viewed 605 times
Note: these devices only sense accumulator discharge rate; consider using a complementary autobreaker (or similar) to sense and control the state of charge of your accumulators.

mmmPI
Smart Inserter
Smart Inserter
Posts: 3152
Joined: Mon Jun 20, 2016 6:10 pm
Contact:

Re: Brownout Alarm (accumulator discharge rate sensor)

Post by mmmPI »

Pretty cool

Post Reply

Return to “Combinator Creations”