Factorio Forums

Ok, downloaded the update and did a quick test in Sandbox.

Can confirm that switching wall types out several times quickly will still cause a crash. In this case it wasn't quite while the previous wall was despawning, but on like the third wall type to be placed on a tile within a few seconds.



(My testing area being those 5 tiles in the middle of the green wall there. The crash seemed to happen while placing back down green again, after being a blue tile, purple tile and purple gate. But that could be either coincidence, or a slight delay between cause and effect, or anything.)

And another one. Apparently if you accidentally set off a nuke near your defences and take out a whole bunch of walls at once, it'll still crash. Maybe a race condition, multiple walls dead per tick?
I don't think any of the emitters were hit in that blast though.

That's a worrisome one. Looks like it might have something to do with gates though.

Have 2 errors, maybe they are related to the upper one ... seems like those walls are missing a robot mining events ... but actually i have no clue xD

You don't mine the walls directly, in fact they should be unminable. If Creative Mode is messing with that, then that's Creative Mode's fault and not mine.

Okay, u r right ... tested without creative mode and issue is gone, so you might add this as an incompatibility.
Same goes for "Nanobots: Early bots" building the walls via those robots creates a non game crashing error (see picture) but the placed wall-plates are bugged and do not spawn a wall. Also mining such a bugged plate by hand will crash the game. I'll report this to Nanobots as well. If the placement gets fixed this would be awesome

I came to report a similar conflict with creative mode. Pasting any blueprint with a flooring tile crashes the game. I'll go and post this on the creative mod thread as well.