Page 1 of 1

Problem with inserters and furnaces

Posted: Thu May 02, 2019 5:06 pm
by FactorioPLayer
Is it possible to insert coal from furnace to furnace, joining belt with coal by inserter only with first furnace in row? To ease yours understanding i put screen below. Those chain made by furnaces and inserters marked by red circle unfortunately doesn't work. Does it mean that it's impossible or i just did something wrong ?
Factorio.jpg
Factorio.jpg (896.26 KiB) Viewed 3004 times

Re: Problem with inserters and furnaces

Posted: Thu May 02, 2019 6:26 pm
by steinio
Only with mods:
https://mods.factorio.com/mod/BurnerLeech%20A16%20Fix
https://mods.factorio.com/mod/InserterFuelLeech

Best way is to make a shared coal line in between iron and steel plates and use long inserters to carry the iron plates over.

Re: Problem with inserters and furnaces

Posted: Fri May 03, 2019 10:41 am
by Serenity
steinio wrote: Thu May 02, 2019 6:26 pm Best way is to make a shared coal line in between iron and steel plates and use long inserters to carry the iron plates over.
You can also have a mixed ore/coal belt on the input. And a mixed steel/coal belt on the output. Then filter the steel at the end

Re: Problem with inserters and furnaces

Posted: Wed May 08, 2019 8:51 am
by vanatteveldt
Or you have a mixed coal / ore input belt and put the furnaces next to each other so they both draw from the same belt. You get very long smelter lines this way, but it has the same width as other smelters which can be an advantage.

Re: Problem with inserters and furnaces

Posted: Wed May 08, 2019 8:54 am
by eradicator
There's a mod for that: https://mods.factorio.com/mod/BurnerLeech%20A16%20Fix
No idea if it works with filter inserters though. Because if you use unfilted inserters there you'll just end up with steel in every furnace.

Re: Problem with inserters and furnaces

Posted: Wed May 08, 2019 6:42 pm
by DerGraue
I would highly recommend you to not use mods to solve that problem.

There are many ways to build your factory, figuring out how, that is the fun part.

And no, you can not take coal from one furnace to fuel another one.

Re: Problem with inserters and furnaces

Posted: Wed May 08, 2019 7:07 pm
by eradicator
DerGraue wrote: Wed May 08, 2019 6:42 pm I would highly recommend you to not use mods to solve that problem.
As a mod author (not of the mod posted above) i highly recommend using mods for everything.
The earlier you start, the more fun you have :P

Re: Problem with inserters and furnaces

Posted: Thu May 09, 2019 4:43 am
by Skeletpiece
DerGraue wrote: Wed May 08, 2019 6:42 pm I would highly recommend you to not use mods to solve that problem.

There are many ways to build your factory, figuring out how, that is the fun part.

And no, you can not take coal from one furnace to fuel another one.
+1