Factorio Forums

Hi I'm having a problem with my train setup, I don't know how to make it work even with only one at a time. With just one train I should be able to make it work without any signals, right? I have 2 stations and both of them at the right side of the rail, and the conditions right (I think), and manualy driving works just fine, I don't know what to do.

Hey etevago I have found learning about trains challenging and frustrating.
Yes, signals are only to avoid train collisions, so with only one train, you don't need any signals. That said unless you are planning to only ever have one train, you might want to start playing with signals now.
If manual driving works, the only thing I can think of is, are you driving the train both forward and backward? Trains in factorio only drive forward, so you have to have a loop, or a way for the train to turn around - or of course to have two locomotives on the train, one facing forward and one facing backward.
Cheers

Oh and I just picked up on one other thing you said "conditions just right" - are you using the circuit network to enable and disable the train stations? On the map, there is a train station icon, you click it to turn station names on and off on the map. If the station is disabled, the station name will show up in red on the map (and in the schedule accessed from the locomotive itself).

Well, trains can go both ways, you just need engines at either end facing opposite directions. Are you getting a "No Path" from the engine? If so, assuming no signaling, you have a break in the track somewhere. Otherwise either there is a break in the track or the signaling is busted. If you can't find the problem at first, trying manually driving the train part way and then try again switching to automatic. Doing this you should be able to eventually find the signalling getting in the way.

You can't have both stations on the same side of the same track. Pay attention the yellow arrows you get when placing a train station. That's the direction the train travels in. Or maybe when you say "right" you mean "correct"

Trains can't travel backwards automatically so without loops you need two locomotives

Either one works:

A screenshot (possibly also a savegame) will help us understand what the problem is.

I normally recommend https://www.reddit.com/r/factorio/comme ... ts_23_and/ to anyone struggling with trains.

@Serenity is correct. The OP states that both stations are on the same side of the track on single track line. That means the train can't get to the station behind it unless there is a loop.

Put one of the stations on the other side of the track and it'll work.