Use the status of electricity as input for logics
Posted: Fri Dec 28, 2018 11:08 pm
Hi,
I want to use the electricity (power) as an input for the logics.
So I want to turn on a backup system when electricity production is below a certain percentage. But I do not get the electricity to show up as input for the calculators....
Any sugestions are apreciated!
Thank you a lot!
Best regards, Eru
I want to use the electricity (power) as an input for the logics.
So I want to turn on a backup system when electricity production is below a certain percentage. But I do not get the electricity to show up as input for the calculators....
Any sugestions are apreciated!
Thank you a lot!
Best regards, Eru