Page 1 of 1
Pump does not work in some positions
Posted: Sat Dec 01, 2018 12:50 pm
by Redstone_Tesla
I can not make this pump work. I already tested it without the circuit and it still does not work.
https://imgur.com/5qvgglc
Can someone help me?
Re: Pump does not work in some positions
Posted: Sat Dec 01, 2018 1:21 pm
by Zavian
Not really enough info to be sure, but I think I recall an issue of pumps not connecting properly if the station isn't straight. (And I think the train must be in automatic mode as well).
Re: Pump does not work in some positions
Posted: Sat Dec 01, 2018 2:21 pm
by nosports
i think the train is not stopped properly.....
To be sure place a railstation signal on a straight vertial or horizontal rail......
Re: Pump does not work in some positions
Posted: Sat Dec 01, 2018 2:41 pm
by eradicator
Zavian wrote: ↑Sat Dec 01, 2018 1:21 pm
Not really enough info to be sure, but I think I recall an issue of pumps not connecting properly if the station isn't straight.
This. Pumps can not connect to trains if the station has curved rails. It won't work regardless of what you try. Curved stations sadly aren't supported for anything. They don't work correct with inserters either, where positions are shifted.