Factorio Forums

I haven't been able to test all the new conditions since I played in .13, but is there a way to signal a train to move to the next station when a single wagon has fulfilled its purpose? I'm thinking about using longer trains to move materials to multiple stations on the same circuit, but don't know if it is possible. I saw there is an option to move on Idle, but don't know if that means what it sounds like.

A good example, is that I'd love to empty a car, then load it back up with the final product, like say Green Circuits. But if I conditioned it to move on empty, it would leave too quickly, and if I set it to leave on full, it wouldn't go because only one car would be filled, versus the two used to start production.

Set it to leave on "Circuit: Electronic circuit = 8000".

Use a green wire to connect the station to a power pole. This enables the circuit interface. Make sure the circuit interface has "Send to train" and "Read train contents" checked.

Oh that should have been obvious!

or you can set cargo:3000 Circuit
Think that does the same thing

It does.