Factorio Forums

I build my first railway after researching everything I most likely (rails, automation, etc).
I have two train stations and a ready train. Now it is telling me after I set the route that there is 'no path'.
I can ride it manually just fine.
What am I doing wrong? Current map with the tracks and stops:

Savegame would help

One shot in the dark: Eventually the same problem as here: https://forums.factorio.com/forum/vie ... =18&t=3654

Check if it's also your problem, my answer from there: "I have had a look into your savegame.. You built the station one square too high. Its not near a straight railwaytrack now. You seem to have build the station, then deconstructed the tracks nearby. Just rebuild the train station or rebuild the loop with adding at least one straight track element near the station."

Rebuild the train station, then try again.

Had to place one extra track in front of one station. Thanks.
Edit: Sorry I was wrong. Only works one way.

Now it is solved for real. I think I cut the track behind the station too short with a signal.