I added a couple trains to my little base. One working on a remote coal mine, and one on a remote iron mine. The remote iron mine is dwindling down, so I scouted out another iron location and branched my iron track off toward to new iron spot to the east, which makes it cross the coal tracks.
I set up a 4 way crossing, I added signals so when I actually have an iron train that would cross with the coal track, they won't collide. However, the coal train now gives me a No Path error. According to all of the wiki articles and youtube stuff I've seen the signals are in the correct locations. The train has engines on both ends. It just needs to go to one end of the line, then the other.
Someone tell me what I need to change to make the trains not error out.
Simple train issue is boggling me....
-
- Fast Inserter
- Posts: 171
- Joined: Sun Feb 17, 2013 4:31 pm
- Contact:
Re: Simple train issue is boggling me....
Needs signals on both sides for 2 way travel
Signal Rail Signal
S || S
Signal Rail Signal
S || S
Last edited by Rockstar04 on Wed Apr 13, 2016 1:22 pm, edited 1 time in total.
Re: Simple train issue is boggling me....
Didn't realize that, that fixed the train route immediately.....Rockstar04 wrote:NEeds signals on both sides for 2 way travel
Signal Rail Signal
S || S
-
- Fast Inserter
- Posts: 183
- Joined: Sun Mar 20, 2016 11:49 pm
- Contact:
Re: Simple train issue is boggling me....
It wasn't on the wiki until now. Now it is there, so hopefully it will help.herkalurk wrote:Didn't realize that, that fixed the train route immediately.....Rockstar04 wrote:NEeds signals on both sides for 2 way travel
Signal Rail Signal
S || S