Factorio Forums

i seam to be having some sort of oddball issue right now. this setup worked before without the chain lights and not sure if this is the cause of the problem. my trains will gladly come into the station but they will not reverse out saying no path did i mess something up?

Main Station Dropoff ISSUE


Junction


Station Pickup ISSUE

easiest way to see where the issue is is to activate the train path debug overview with F4 and inch the train along to see at what point the path exists again

found issue for some reason it didnt like the pickup tracks

harmar wrote:found issue for some reason it didnt like the pickup tracks

I think it was because your chain signal and regular signal were misaligned on the entrance to that final block occupied by the station, judging by the picture.

If you point at one of two signals that should be a pair, and the other doesn't get highlighted with a bracket, then something's out of place.

harmar wrote:found issue for some reason it didnt like the pickup tracks

I think the problem is that you cannot actually get from the rightmost side to the exit since the north and south curves slightly overlap. Middle track should be able to leave though.