Gleba doesn't support peaceful mode?

Don't know how to use a machine? Looking for efficient setups? Stuck in a mission?
mortoray
Burner Inserter
Burner Inserter
Posts: 5
Joined: Fri Nov 22, 2024 3:11 pm
Contact:

Gleba doesn't support peaceful mode?

Post by mortoray »

I'm playing on peaceful mode, but then I reached Gleba. The enemies there continually attack my structures even though I've done nothing to them. The worst are those stomper pentapods since they're hard to kill.

Is this intended? It feels like it should be, well, peaceful. Unless I attack them, they should leave me alone.


*sigh*

It just walked through an destroyed everything that I setup. I'd effectively have to start over, or find an earlier save point.

Note: I'm aware of the eggs that spawn little guys when they spoil. I feel that's fine, since it's my own created problem and adds a nice challenge.
mortoray
Burner Inserter
Burner Inserter
Posts: 5
Joined: Fri Nov 22, 2024 3:11 pm
Contact:

Re: Gleba doesn't support peaceful mode?

Post by mortoray »

This is seriously ruining my fun. I enjoy the challenge of Gleba starting form scratch, were it not for the attacks.

Super frustrating.
simon4096
Burner Inserter
Burner Inserter
Posts: 6
Joined: Sat Nov 09, 2024 12:53 pm
Contact:

Re: Gleba doesn't support peaceful mode?

Post by simon4096 »

Enemies should not be forming attack groups due to spore clouds in peaceful mode. You should probably report this as a bug if you haven't yet. It might also be a mistake when configuring the map though.
mortoray
Burner Inserter
Burner Inserter
Posts: 5
Joined: Fri Nov 22, 2024 3:11 pm
Contact:

Re: Gleba doesn't support peaceful mode?

Post by mortoray »

Is there a console command I can check to see if something is wrong?

They're now forming very large attack groups, with two of the stompers and several other ones to come attack my base. :(
BenSeidel
Filter Inserter
Filter Inserter
Posts: 591
Joined: Tue Jun 28, 2016 1:44 am
Contact:

Re: Gleba doesn't support peaceful mode?

Post by BenSeidel »

Unsure if there is a console command, but you can use the "Map Exchange String" in the top right hand side of the "Load Game" window.
You can then paste that string into the "Import Map Exchange Sting" dialogue box in the "Map Generator" window when creating a new game. This will set all the configurations of the window to be the same as the configuration you hand when you created your saved game (and hence let you play it again).
Post Reply

Return to “Gameplay Help”