"Enabled Condition" Broken?
-
- Manual Inserter
- Posts: 4
- Joined: Fri Jan 19, 2018 5:31 am
- Contact:
"Enabled Condition" Broken?
I am trying to set an inserter to take out uranium 235 from a chest, but when I set it to [Uranium-235 > 40], it never does anything. But if I replace the > with a <, it will just try to empty the chest like there is no enable condition thing at all. Is this a bug, or am I doing something wrong?
Last edited by CyrenArkade on Fri Jan 19, 2018 6:13 am, edited 1 time in total.
Re: "Enabled Condition" Broken?
Maybe should you set it to U-235 or U-338 on bith sides ?
A screenshot of yout setup or the save would help.
A screenshot of yout setup or the save would help.
Koub - Please consider English is not my native language.
Re: "Enabled Condition" Broken?
You mixed up 235 and 238.
-
- Manual Inserter
- Posts: 4
- Joined: Fri Jan 19, 2018 5:31 am
- Contact:
Re: "Enabled Condition" Broken?
Oops, I accidentally put 238 in the brackets instead of 235. My bad!Koub wrote:Maybe should you set it to U-235 or U-338 on bith sides ?
A screenshot of yout setup or the save would help.
-
- Manual Inserter
- Posts: 4
- Joined: Fri Jan 19, 2018 5:31 am
- Contact:
Re: "Enabled Condition" Broken?
Yes, it is indeed wired up and not workingDaveMcW wrote:Is the inserter actually wired to the chest?
Re: "Enabled Condition" Broken?
Please make a screenshot of your setup zoomed in + inserter interface open. Also show your chest contents.
Seams like the inserter and a corresponding chest are not connected via colored wire or you misplaced other material in a condition.
This is intended behaviour if inserter has no input of set material (so it is =0 and is definitely < 40) and it works then.But if I replace the > with a <, it will just try to empty the chest like there is no enable condition thing at all
Seams like the inserter and a corresponding chest are not connected via colored wire or you misplaced other material in a condition.
-
- Manual Inserter
- Posts: 4
- Joined: Fri Jan 19, 2018 5:31 am
- Contact:
Re: "Enabled Condition" Broken?
I found the problem. I accidentally connected it to a logistics network at some point.