[Genhis] [1.1.38] Blueprint snapping rectangle flag renders behind part of roboport graphic.
Posted: Mon Aug 23, 2021 8:07 pm
Problem description:
The little flag showing the center of the blueprint snapping rectangle doesn't render if there's a roboport in the way.It would seem the flag renders under a layer of the roboport graphic.
Steps to reproduce:
- Create a blueprint of consisting only of a roboport.
- Enable snap to grid.
Expected behavior:
The red flag indicating the center of the snapping rectangle should be visible.Image example:
- no-problem.png (31.1 KiB) Viewed 3212 times
Observed behavior:
It doesn't.Image example:
- problem.png (30.45 KiB) Viewed 3212 times