[0.17.42] Crash when placing train blueprint
Posted: Tue May 21, 2019 8:35 pm
I placed one train by blueprint (1:2), then tried to put a locomotive at the end (opposite direction) by using the same (rotated) blueprint, crash. The wagons were overlapping, there was enough room on the straight rail.
Noteworthy, previous attempt was successful.
EDIT:
tried to repeat the scenario. When the wagons overlap and I left-click, crash. Shift+left-click, ghost is placed, locomotive gets built.
While only ghosts are present, a correct "Cargo wagon ghost is in the way" message is shown. Once the train is built, attempting to place blueprint (of a carriage of any type) results in a crash.
Noteworthy, previous attempt was successful.
EDIT:
tried to repeat the scenario. When the wagons overlap and I left-click, crash. Shift+left-click, ghost is placed, locomotive gets built.
While only ghosts are present, a correct "Cargo wagon ghost is in the way" message is shown. Once the train is built, attempting to place blueprint (of a carriage of any type) results in a crash.